Serpent 811-Be Cobra 1/8 4wd Buggy EP

Serpent 811-Be Cobra 1/8 4wd Buggy EP
Serpent 811-Be Cobra 1/8 4wd Buggy EP

Serpent 1/8 scale buggy in electric powered version. Serpent Cobra Buggy E. The Cobra 811e is based on the same platform as the gaspowered buggy. State of the art design of the central section, with advanced integrated standing servo, receiver, speedo bracket, ingenious motor-bracket and lay-down Lipo-pack configuration with practical lid-system. Extremely narrow and low design, optimised for overall weight balance. New low body-design and lower rear wing / wingmount.

Ready mid july 2011

Serpent 811-Be Cobra Chassis Shot
Serpent 811-Be Cobra Chassis Shot

[source: www.serpent.com]

My Zimbio

  

About Tony Phalen

Tony Phalen - As an avid RC enthusiast, Tony has been building, bashing and racing RC Cars for over 25 years. He has raced everything from 1:18th scale trucks to 1:5 scale motorcycles and everything in-between. He's also worked on both sides of the industry fence; working at and with many major manufacturers (as well as being a sponsored driver) to working for a high-profile industry magazine. During this time he has learned many tricks, tips and techniques and has transferred that knowledge to CompetitionX - the most informative RC website on the internet! More articles by Tony Phalen

Check Also

Review: Serpent SDX4 Competition 4WD Buggy

Review: Serpent SDX4 Competition 4WD Buggy

A Serpent Has Slithered Into Your Pit Space For years 4WD buggy racing has been …

Leave a Reply

Your email address will not be published. Required fields are marked *