In Part 3 of this multi-part Tekno ET48 2.0 build series, we take you through the steps of building the entire rear clip – bulkhead, anti-roll bar and suspension. Since we skipped around a bit in Part 2 (as far as bag builds), we’ll be getting ourselves back on track as far as the bags are concerned.
Enjoy the video.
//TOOLS USED IN THIS VIDEO
MIP 1.5mm Hex Wrench: https://bit.ly/330HjTB
MIP 2.0mm Hex Wrench: https://bit.ly/2Gb8G5k
MIP 2.5mm Hex Wrench: https://bit.ly/3jsxR1M
MIP Tools 3-Pack (1.5, 2.0, 2.5): https://bit.ly/3gQ7t06
ProTek Nut Driver Set (5.0, 5.5, 7.0, 8.0): https://bit.ly/35jDdrj
STRC Shock Pliers: https://bit.ly/2LynD41
ProTek Curved Scissors: https://bit.ly/2QIa9SD
Excel Needlenose Pliers: https://bit.ly/2Gk7soA
Excel Hobby Knife: https://bit.ly/3s0q1kn
Hudy 17mm Wheel Nut Tool: https://bit.ly/3sLCR7c
STRC Aluminum 4mm/5mm Turnbuckle Wrench: https://bit.ly/3tpiFYD
ProTek Calipers: https://bit.ly/3lHx5jd
ProTek Double-Sided Tape: https://bit.ly/2QHb3ix
ProTek Shock Stand: https://bit.ly/2Xysmpv
//RC GEAR WE USE
//CHECK OUT OUR MERCH
Notice: Some of our articles, videos and descriptions may contain affiliate links, which means that if you click on one of the product links, we may receive a small commission. This helps support the website and social media channels and allows us to continue to produce content. Thank you for the support!
#teknorc #teknoet4820 #teknotakeover #competitionx #tonyphalen