In Part 4 of our Tekno RC ET48 2.0 build series, we assemble the steering system, attach it to the front clip and add that to the chassis. We’ll also be installing the rear clip to the chassis as well as the center bulkhead, center diff and front/rear drive shafts.
Enjoy the video.
//TOOLS USED IN THIS VIDEO
MIP 1.5mm Hex Wrench: https://bit.ly/330HjTB
MIP 2.0mm Hex Wrench: https://bit.ly/2Gb8G5k
MIP 2.5mm Hex Wrench: https://bit.ly/3jsxR1M
MIP Tools 3-Pack (1.5, 2.0, 2.5): https://bit.ly/3gQ7t06
ProTek Nut Driver Set (5.0, 5.5, 7.0, 8.0): https://bit.ly/35jDdrj
STRC Shock Pliers: https://bit.ly/2LynD41
ProTek Curved Scissors: https://bit.ly/2QIa9SD
Excel Needlenose Pliers: https://bit.ly/2Gk7soA
Excel Hobby Knife: https://bit.ly/3s0q1kn
Hudy 17mm Wheel Nut Tool: https://bit.ly/3sLCR7c
STRC Aluminum 4mm/5mm Turnbuckle Wrench: https://bit.ly/3tpiFYD
ProTek Calipers: https://bit.ly/3lHx5jd
ProTek Double-Sided Tape: https://bit.ly/2QHb3ix
ProTek Shock Stand: https://bit.ly/2Xysmpv
//RC GEAR WE USE
//CHECK OUT OUR MERCH
Notice: Some of our articles, videos and descriptions may contain affiliate links, which means that if you click on one of the product links, we may receive a small commission. This helps support the website and social media channels and allows us to continue to produce content. Thank you for the support!
#teknorc #teknoet4820 #teknotakeover #competitionx #tonyphalen